Emergency Electrician in Jeddah
Some electrical faults can wait until morning and some cannot. The difference matters, so this page explains it before it explains how to reach us.
What actually counts as an emergency
Sparking from a socket or board, a burning or melting-plastic smell, unusual heat at a socket or switch, crackling from the distribution board, or water reaching electrical wiring — none of these wait. Nor does a total loss of power to your property when the rest of the street still has supply. A single dead light or one non-working socket, by contrast, can be scheduled for the next day at lower cost.
What to do before we arrive
Switch off at the main breaker if the board is safe and dry to reach. Don't touch any wet appliance or cable, and don't keep resetting a breaker that trips immediately — repeated tripping means the breaker is doing its job and preventing a real hazard. Keep children away from the area, and if there's a burning smell, open windows to ventilate.
Why faults cluster in a Jeddah summer
Most of the emergency calls we take between June and September are not coincidence. Heat reduces how much current a cable can safely carry, so a circuit that is comfortable in January can be running at its limit in August. On top of that, air conditioners run for far longer and pull a large surge each time the compressor starts, loading circuits that were never designed for that duty cycle. Near the coast, humidity and salt-laden air accelerate corrosion on terminals and connections in distribution boards and outdoor sockets — and a corroded terminal runs hot, while heat is what eventually causes the failure. Heat, load and corrosion together explain most of what we see in the summer months.
What happens when we arrive
The first step is always isolating the supply and making the area safe, not fixing the fault. We then inspect the board and the affected circuits for heat damage, charring or a loose termination, and bring circuits back one at a time to identify the one responsible rather than guessing. Where the cause is earth leakage, we disconnect loads from that circuit in sequence until the offending appliance or cable section is isolated. The goal of an emergency visit is a property that is safe and a fault that is understood — and that sometimes means leaving one circuit switched off until a part can be replaced on a scheduled visit, which is far better than re-energising something still dangerous.
Wait until morning, or call now?
A quick guide to common symptoms. When in doubt, treat it as urgent and isolate the supply.
| What you notice | Likely cause | What to do |
|---|---|---|
| Sparking or crackling at the board | Loose termination or arcing | Call now — isolate supply |
| Burning or melting-plastic smell | Overheating insulation or terminal | Call now — isolate supply |
| Socket or switch hot to the touch | Overload or poor connection | Call now — stop using it |
| Breaker trips the instant you reset | Short circuit or earth leakage | Call now — leave it off |
| Water has reached a board or cable | Direct shock risk | Call now — keep clear |
| No power, but neighbours have supply | Service head or board fault | Call now |
| Whole street is dark | Network outage | Wait — an electrician can't help |
| Breaker trips once every few days | Intermittent overload or faulty appliance | Can be scheduled |
| One light or socket dead | Localised fault | Can be scheduled |
Call us immediately if you notice
Sparking from a socket, switch or distribution board
A burning or melting-plastic smell
Sockets or switches hot to the touch
A breaker that trips instantly every time you reset it
Water that has reached wiring or a distribution board
Total power loss to your property while neighbours have supply
Frequently Asked Questions
Yes. The emergency line is open 24 hours a day, every day including Fridays and public holidays, on 0564036091. Non-urgent scheduled work runs Saturday to Thursday, 8am to 8pm.
No. A breaker that trips the instant you reset it is signalling a short circuit or earth leakage, and it is preventing a genuine hazard. Repeated attempts can damage the breaker itself and remove that protection. Leave the circuit off and call us.
Look at neighbouring buildings and the street lighting. If they have power, the fault is inside your property and needs an electrician. If the whole area is dark, it's a network outage and calling an electrician won't help.
Your district and address, a description of what happened and when it started, and whether you've isolated the supply. That lets us bring the right parts on the first visit rather than needing a second.
Yes, if the board is dry and you can reach it without passing through water or smoke. Switch off the main breaker. Don't touch the board if it is wet, hot, or making a noise. If you can't reach it safely, leave it to us and move away from the area.
Not necessarily, but it isn't something to live with either. Tripping tied to one appliance usually points to an overloaded circuit or a fault inside the unit. Stop using that appliance on that circuit and book a scheduled visit. If the tripping comes with a smell, heat or noise, it becomes urgent.
Often yes, because we carry common parts. But the first purpose of the visit is to make the property safe and establish the cause. If the repair needs a part we don't have with us or work that takes longer, we leave the property in a safe state and finish on a scheduled visit.